3. Using a network ping app, such as Ping by Lipinic, ping IP address 192.168.1.2 – if successful your Wi-Fi extender is alive and can connect to the P2V+ Wi-Fi, i.e., binding is ok. If ping fails there is another issue so go no further. 4. Ping IP address 192.168.1.1 – if successful the top PCB within the Wi-Fi module is working. If Just bought a phantom 3 std Trying to set it up and after charging the batteries and fitting props get a beep and alive signal. Trouble is it just does not seem to be connecting between the Phantom and the control unit Will not connect to the internet , says signal too slow, but it's the same Flight distance : 283930 ft. + Add Friend Person Message. Offline. 1#. The tilt and pan on the camera/gimbal quit working yesterday. When I turn on the Mavic, the gimbal moves thru normal start up. The left thumbwheel turns but doesn't move the camera. I tried moving the camera in the app on my phone but that didn't work either. I got a new Phantom 2 with H3-3D gimbal, iOSD mini, and fpv. Got everything mounted and hooked up. I powered up to test the fpv, gimbal, and iOSD and all worked fine. Then I wanted to make sure all firmware was updated before first flight, as many have stated this was imperative to prevent potential fly-always. Firmware seemed to update properly. Then I power cycled and now the gimbal does It takes 2.5-3 hours to charge a remote controller Phantom 3 Professional or Advanced controller, and 4.5-5 hours to discharge them (while they’re connected with a mobile device). It takes longer if there’s no mobile device connected. Charging time for Phantom 3 Standard’s remote controller depends on which charger you’re using. Options DJI Phantom 2 Repair The DJI Phantom 2 is a quadcopter with an optional brushless camera gimbal produced by DJI. It has a 25-minute maximum flight time and an automatic return-to-home and landing feature but does not include a camera. It was released in December 2013. Author: Jose Gustavo Abreu Murta (and 5 other contributors) Ff4eE. Reset Phantom controllers fix. Turn off the remote controller. Press the C1, C2, Record, and the Camera settings all at the same time. Hold these for about 2 seconds. When you have done that turn on the remote. When you turn the remote on you will see the LED turn blue. This means the controller has been reset. Mavic Pro disconnecting mid flight 3. Press and hold the image transmission screen on the DJI GO 4/GO app. After a blue circle appears, drag it up or down to control the gimbal. If the gimbal moves accordingly, the gimbal can work normally. 4. Tap “Advanced Settings” under “Gimbal Settings”. Check whether “Max Gimbal Pitch Speed” is set to 1. Step 2: use "recover_mp4_to_h264.exe" to create a new mp4 file from the damaged one, using the reference file's avcc you just created in step 1. Step 3: use mp4muxer.exe to create an mp4 from the newly created h264 you created in step 2. voila!~. It's sounds like a hot mess of stuff to do, but it truly is simple. DJI is dedicated to offering everyone a flying camera platform and taking photography to new heights. The DJI VISION App is associated with the PHANTOM 2 VISION. It allows full remote camera control through a mobile device. This App is only for the operation of the PHANTOM 2 VISION. PHANTOM 2 VISION -- Your Flying Camera. - Long Flight Times. The camera does work, I can record video and take pictures to be viewed on my computer from the SD card. Whether I use an iPad or iPhone, the Go app does not display the HD Live video, I have a red "No Connection" message at the top of the app however signal strength for the controller and HD are both strong.

dji phantom 2 camera not working